Add board profile for Pcduino3

diff --git a/src/adafruit_blinka/board/linksprite/__init__.py b/src/adafruit_blinka/board/linksprite/__init__.py
index 9a9ed7399d38f1a06d8f807c90a14dd19a4f9796..333c1b181f2ac71a346555c50c76b6e3916c9ba3 100644 (file)
--- a/src/adafruit_blinka/board/linksprite/__init__.py
+++ b/src/adafruit_blinka/board/linksprite/__init__.py
@@ -1 +1 @@
-"""Boards definition from Linksprite Pcduino"""
+"""Boards definition from Linksprite Pcduino based boards"""

diff --git a/src/adafruit_blinka/board/linksprite/pcduino3.py b/src/adafruit_blinka/board/linksprite/pcduino3.py
new file mode 100644 (file)
index 0000000..cb08490
--- /dev/null
+++ b/src/adafruit_blinka/board/linksprite/pcduino3.py
@@ -0,0 +1,65 @@
+"""Pin definitions for the Pcduino3."""
+from adafruit_blinka.microcontroller.allwinner.a10 import pin
+
+#Pin wise this is the same as the Pcduino2 but features a daul core A20 rather than a single core A10
+
+#J11 Header
+D0 = pin.PI19
+D1 = pin.PI18
+D2 = pin.PH7
+D3 = pin.PH6
+D4 = pin.PH8
+D5 = pin.PB2
+D6 = pin.PI3
+D7 = pin.PH9
+
+#J8 Header
+D8 = pin.PH10
+D9 = pin.PH5
+D10 = pin.PI10
+D11 = pin.PI12
+D12 = pin.PI13
+D13 = pin.PI11
+SDA = pin.PB21
+SCL = pin.PB20
+
+#J9 Header
+#A0 & A1 are LRADC pins with only 6-bit resolution and unlike other pins are only limited to 2v
+A2 = pin.XP_TP
+A3 = pin.XN_TP
+A4 = pin.YP_TP
+A5 = pin.YN_TP
+
+#P7 Header
+SCLK = D13
+SCK = SCLK
+MOSI = D11
+MISO = D12
+CS = D10
+
+
+#P6 Header
+SCLK2 = pin.PC20
+SCK2 = SCLK2
+MOSI2 = pin.PC21
+MISO2 = pin.PC22
+CS2 = pin.PC19
+
+#P10 Header
+D14 = pin.PH11
+D15 = pin.PH12
+D16 = pin.PH13
+D17 = pin.PH14
+
+UART2_TX = D1
+UART2_RX = D0
+UART5_TX = D3
+UART5_RX = D2
+
+PWM0 = D5
+PWM1 = D6
+
+#Misc
+BACK_SW = pin.PH17 #Three buttons featured on the board
+HOME_SW = pin.PH18
+MENU_SW = pin.PH19
\ No newline at end of file